Platform hardware
| Item | Purpose |
|---|---|
| VIPER interface unit | Holds power modules and exposes power and signal connections. |
| Preconfigured Raspberry Pi 5 and touchscreen | Runs VIPER and provides local controls. |
| Pi USB-C power supply | Powers the Pi. |
| Total Phase Aardvark | Controls the power supplies through I2C. |
| Total Phase Beagle | Captures I2C traffic. |
| PicoScope 4424A or 4824A | Captures four or eight waveform channels. |
| PicoScope DC adapter and probes | Powers the scope and connects signals. |
| I2C, USB, and Ethernet cables | Connect the kit components. |
Power-module options
| Kit | Installed power modules |
|---|---|
| VIPER-00 | None. |
| VIPER-50 | One VPX55HS. |
| VIPER-70 | One VPX57HS. |
| VIPER-55 | Two VPX55HS supplies; current-share capable. |
| VIPER-77 | Two VPX57HS supplies; current-share capable. |
| VIPER-5B | One VPX55HS and one VPX-BEHU 625 W hold-up module. |
| VIPER-7B | One VPX57HS and one VPX-BEHU 625 W hold-up module. |
Do not mix VPX55HS and VPX57HS supplies in the same kit. The hold-up module occupies the second power-module slot. See the VIPERA001 data sheet, page 9, for ordering information.
Equipment you provide
Provide a computer with a browser, an Ethernet switch, an appropriate input source, and rated test leads. Match the source’s input type, voltage, and capacity to the installed supply and intended load.
Contact NAI Support about missing components or configuration questions.
Continue with Hardware setup or Quick Start.